Cradlepoint COR IBR1100/IBR1150 Manual page 77

Wired 802.1X: (requires hardware version 2.0) This allows you to configure an authentication server that will accept authentication requests from devices attached to wired
Ethernet ports. IEEE 802.1X defines the encapsulations of the Extensible Authentication Protocol (EAP).
Click Enable 802.1X to require IEEE 802.1X authorization for the Ethernet ports associated with this network.
Reauthentication Period: EAP re-authentication period in seconds.
Authentication settings
Auth Server IP Address: This is the IP address of the connected RADIUS server.
Auth Server MAC Address: This is the hardware address of the connected RADIUS server's interface. NOTE: If you don't know the MAC address for
the RADIUS server, enter 00:00:00:00:00:00 and the service will try to find the MAC address from the given IP address.
Port: 1812 is common for the authentication port.
Password: Assigned by the RADIUS server.
Accounting settings: Most of the accounting settings often match the authentication settings, depending on whether the RADIUS server is the same for both authentication
and accounting.
Acct Server IP Address
Acct Server MAC Address
Port: 1813 is common for the accounting port.
Password
Local Network Interfaces
Each LAN type – WiFi, Ethernet, and VLAN – has a separate section with configuration options. Unless the default configuration is sufficient, YOU MUST CONFIGURE EACH
INTERFACE SEPARATELY in order to create the desired interface options for a network. You can then select these interfaces to add to a network in the Local Network
Editor (see above).
10/13/2014
CradlePoint COR IBR1100/IBR1150 – Manual
77