Cradlepoint COR IBR1100/IBR1150 Manual page 11

RESET (power and factory reset button)
On – Press and hold for one second to turn on. Multiple LEDs turn on to signal that the router is on. RELEASE THE BUTTON BEFORE FIVE SECONDS TO
PREVENT THE ROUTER FROM TURNING OFF AGAIN.
Off – Press and hold for five seconds to turn off. The USB and modem lights turn red to signal that the router will turn off upon release. RELEASE THE BUTTON
BEFORE TEN SECONDS TO PREVENT FACTORY RESET.
Factory reset – Press and hold for ten seconds to factory reset the device. The USB and modem lights turn amber and blink twice to signal factory reset. This
returns all settings to factory defaults.
NOTE: Using the reset button for turning the device on/off is typically unecessary: the device powers on by default as soon as it receives
power, and it can be configured to sense vehicle ignition with a timed delay for power off.
RS-232 (serial port) – This is a serial DE-9 (commonly called "DB-9"), 9-pin female connector. The pins are numbered from the top right as shown here:
Pin Signal Type
1 RI
2 TxD
3 RxD
4 DSR
5 GND
6 DTR
7 CTS
8 RTS
9 DCD
LEDs
– POWER
Green = Powered ON.
No Light = Not receiving power. Check the power switch and the power source connection.
Flashing Amber = Attention. Open the administration pages (see
– WiFi BROADCAST
These two LEDs indicate activity on the WiFi broadcast for both the 2.4 GHz and 5 GHz bands.
2.4G (green) = 2.4 GHz WiFi is on and operating normally.
5G (blue) = 5 GHz WiFi is on and operating normally.
– EXTERNAL USB MODEM
10/13/2014
Accessing the Administration Pages) and check the router status.
CradlePoint COR IBR1100/IBR1150 – Manual
11