Advertisement
4K/2K RAW Recording
4. SET TIMECODE SOURCE
☼ » SETUP » TIMECODE SOURCE » SDI/HDMI
5. FORMAT SSDs
☼ » ODYSSEY » SSD'S » FORMAT BOTH
SECOND SSD DRIVE INSTALLED.)
6. CONNECT TO CAMERA AND VERIFY STATUS INPUT
Connect FS700 3G-SDI output to Odyssey SDIA input
Note: Use only 3G-SDI rated cables from FS700 to Odyssey. Using a 1.5G SDI cable in not
recommended and may cause issues.
The status on your Odyssey will display your camera's output.
Example:
The recorded file will be RAW (.DNG) 2K or 4K. 2K up to 240fps, 4K up to 60fps (sustained) and
4K 100/120 (3-4 second bursts).
Recording Across Two SSDs (SSD RAID)
4K 23.98p to 30p rates = Single Drive
2K 23.98p to 120p rates = Single Drive
4K 50/59p = RAID (two drives)
2K 200/240p = RAID (two drives)
RAID is set up automatically upon detecting the input signal - no setup is required.
You can use any Convergent Design media; they need not be matching (ie, one 256GB card and
one 512GB card).
Convergent-Design.com
4K 29.97
NOTE
SSD1
SSD2
1, 3, 5, 7...
0, 2, 4, 6...
NOTE
(OR FORMAT SSD1 IF YOU DO NOT HAVE A
FS700
RAW
[7]
Advertisement
