Advertisement
Post Production
Example LUTs
For your convenience, Convergent Design has generated several example LUTs that can be applied to your RAW
footage. Keep in mind these LUTs are an approximation, and may need adjustment depending on your application.
These LUTs are available in the Firmware/Downloads section of the Convergent Design website.
*Also note that using camera metadata or CinemaDNG default is also supported.
To Load 3D LUTs into Davinci Resolve
1.
Select the Project Settings wheel, and navigate to Look Up Tables
2.
Select Open LUT Folder, and copy the included example LUTs into this folder.
3.
Now Select Update Lists
4.
Now in the Media Browser you can right click on your RAW file and select 3D LUT and select the LUT you wish to
apply from the list.
Note the following about each CD example LUT, and you should adjust the LUT based on your application.
FS700_1.11.100_SLOG.cube
(Same LUT is recommended with firmware v2.10.141/3.10.100)
This LUT can be applied to view a simulated S-Log2 look based on the RAW recording with the S-Log2 picture profile,
also note the image should closely match the internal media.
FS700 FCP X Import Settings
Once you have created a new project be sure to check the following Settings:
1.
Under Final Cut Pro select Preferences
2.
Be sure the Still Images editing duration is set to 0.0.1 Seconds
3.
Select navigate to File and select Import Media
4.
Navigate to the Clips directory, and select the Clip Folder contain your FS700 RAW files.
5.
At this point you can start correcting the files to a 2.2 Gamma using the Color Board.
* Note if you are recording the internal media you can import the matching S-Log2 file, and select Match Color for a close
approximation of S-Log2, but will most likely need additional tweaking.
Convergent-Design.com
[19]
Advertisement
