Disposal Of This - Sony RM-LVR2 How To Use Manual

Hide thumbs Also See for RM-LVR2:
Table of Contents

Advertisement

On charging the battery pack
Charge the battery pack before using this unit.
We recommend charging the battery pack in an ambient temperature of between 10°C to 30°C (50°F
to 86°F) until the POWER/CHG (Charge) lamp turns off. The battery pack may not be effectively
charged in temperatures outside this range.
The POWER/CHG (Charge) lamp may blink during charging this unit in the following situations:
Battery pack is damaged.
The temperature of this unit is low. Put it in a warm place.
The temperature of this unit is high. Put it in a cool place.
Effective use of the battery pack
Battery pack performance decreases at a low ambient temperature lower than 10°C (50°F). In cold
places, therefore, the operational time of the battery pack is shorter.
Remaining battery charge
If the battery pack runs out quickly even though the remaining charge indicator is high, fully charge
this unit again. The remaining charge indicator will then be displayed correctly. Note that it may not be
displayed correctly in the following situations:
This unit is used for a long time at high ambient temperature.
This unit is left fully charged.
This unit is used heavily.
On battery pack life
The battery pack has a limited life. Battery capacity decreases over time and through repeated use. If
decreased usage time between charges becomes significant, it is probably time to replace it with a
new one.
The battery pack life varies according to how the battery pack is used.
[65] How to use
Disposal of this unit
Remove the built-in battery pack before disposing of this unit.
Do not remove the screws except when disposing of this unit. We will refuse repairs or replacement if
we judge there to have been unwarranted disassembly.
The built-in battery pack of this unit is recyclable. When disposing of this unit remove the built-in battery
pack and take it to your dealer.
1. Press the ON/OFF (Power) button.
The unit turns off.
2. Disconnect the connected cables.
3. Remove the screws with a Phillips-head screwdriver (4 screws).
4. Detach the cover.
Others
Disposal of this unit

Advertisement

Table of Contents
loading

Table of Contents