Belt Replacement - Windsor CLP12 Operating Instructions Manual

Maintenance

Belt Replacement

Only qualified maintenance personnel are to perform
the following repairs.
Seul le personnel d'entretien qualifié peut effectuer des
réparations.
1. Turn off all switches and unplug machine.
2. Remove recovery tank and brush.
3. Remove the (2) screws that fasten the solution
tank to the frame, and tilt tank back to expose the
inside of the frame.
4. Loosen the (4) screws that hold the brush motor in
place and slide motor forward to release tension in
belt.
5. Remove the (2) screws that fasten the vacuum
shoe links to the brush housing.
6. Remove the (3) screws that fasten the side plate
to the brush housing to remove belt.
NOTE: All components associated with driving the
brush will come out with the side plate.
7. Reverse process to install belt.
28 86403890 Manual Operators - Clipper 12 - 230V