Sanyo VCC-9300P Instruction Manual page 43

ALARM SETTING
Alarm duration setting (DURATION)
Sets the duration of an alarm.
Use the joystick lever (j or l) to move the cursor to
DURATION, then use the joystick lever (d or c) to select the
alarm duration.
Available settings: 5S, 10S, 15S, 20S, 30S, 60S, 2M, 3M, 4M, 5M
Note: The alarm duration setting is only applied for an alarm that
matches the set alarm number. Subsequent alarms for the
same number will not be received during the set amount of
time. However, if an alarm input with a different number is
detected, the alarm will be immediately received and from
that point operation will start based on settings selected for
that alarm number.
B Alarm output setting
1
In the MAIN MENU, select ON for ALARM and press the
ENTER button.
The ALARM screen will appear.
2
Use the joystick lever (j or l) to move the cursor to
ALARM OUT, then use the joystick lever (d or c) to
select the external alarm output number. (Ex: 2) Then
press the ENTER button.
The ALARM OUT 2 screen will appear.
Adjust alarm output settings for ALARM OUT 2 as needed.
3
Canceling a settings screen
•
Use the joystick lever (l) to select BACK for MENU, then
press the ENTER button. The ALARM screen will reappear.
•
To return to the normal screen, use the joystick lever (l
c) to select END for MENU, then press the ENTER button.
External alarm output setting (POLARITY)
Sets the output polarity for outgoing external alarms.
Use the joystick lever (d or c) to select POLARITY between
"NO" and "NC".
•
NO: Normal open
•
NC: Normal closed
External alarm output time setting
(ALARM TIME)
Use the joystick lever (j or l) to move the cursor to ALARM
TIME, then use the joystick lever (d or c) to select the
amount of time for external alarm output.
Available settings: 2S, 5S, 10S, 15S, 20S, 30S, 60S, 2M, 3M,
4M, 5M
– 42 –
ALARM OUT 2
ENTER
POLARITY
ALARM TIME
PRESET
MENU
ALARM OUT 2
POLARITY
ALARM TIME
NO
5S
OFF
BACK
NO
5S
English