Sanyo VCC-9300P Instruction Manual page 42

ALARM SETTING
A Alarm input setting
1
In the MAIN MENU, select ON for ALARM and press the
ENTER button.
The ALARM screen will appear.
2
Use the joystick lever (d or c) to select the external
alarm input number (Ex: 3), then press the ENTER button.
The ALARM IN 3 setting screen will appear.
ENTER
Adjust the alarm input settings for ALARM IN 3 as needed.
3
Canceling a settings screen
•
Use the joystick lever (l) to select BACK for MENU, then
press the ENTER button. The ALARM screen will reappear.
•
To return to the normal screen, use the joystick lever (l
c) to select END for MENU, then press the ENTER button.
External alarm input polarity setting
(POLARITY)
Sets the input polarity for incoming external alarms.
Use the joystick lever (d or c) to select POLARITY between
"NO" and "NC".
•
NO: Normal open (Normally open so closed condition is
detected as input.)
•
NC: Normal closed (Normally closed so open condition is
detected as input.)
English
ALARM IN 3
POLARITY NO
MOVE OFF
MOTION OFF
ALARM OUT OFF
LINE OUT OFF
DURATION 5S
PRESET OFF
MENU BACK
ALARM IN 3
POLARITY NO
MOVE OFF
MOTION OFF
ALARM OUT OFF
– 41 –
Move to preset setting (MOVE)
After activation of an alarm, the camera moves to the PRESET
POSITION with the same number as the alarm number.
Use the joystick lever (j or l) to move the cursor to MOVE,
then use the joystick lever (d or c) to select the preset move
option.
•
ON: When alarm is received, the camera moves to the
PRESET POSITION with the same number as the alarm
number.
•
OFF: Does not move to a PRESET POSITION.
•
AUTO: Moves to PRESET POSITION as with "ON" setting, but
moves back to the surveillance position in use just prior
to the alarm after the amount of time set in DURATION
has elapsed.
Motion sensor input setting (MOTION)
Matches information from the camera's motion sensor and the
external alarm and outputs it.
Use the joystick lever (j or l) to move the cursor to MOTION,
then use the joystick lever (d or c) to select the input.
•
OFF: Does not output a motion sensor alarm.
•
AND: Outputs an alarm if a motion sensor alarm is detected at
the same time an external alarm is received.
Note:
•
The "AND" and "OR" sensor input options are only possible
when MOVE mode is set to "ON".
•
When MOVE mode is set to "OFF", MOTION SENSOR will
automatically be set to "OFF".
•
OR: Outputs an alarm if either a motion sensor alarm or an
external alarm is detected.
Alarm output setting (ALARM OUT)
Selects the port for alarm output.
Use the joystick lever (j or l) to move the cursor to ALARM
OUT, then use the joystick lever (d or c) to set the alarm
output port.
Available settings:
•
1: Output to alarm 1
•
2: Output to alarm 2
•
OFF: Does not output an alarm
Line output setting (LINE OUT)
Sets ON/OFF condition for alarm output to the communications line.
Use the joystick lever (j or l) to move the cursor to LINE
OUT, then use the joystick lever (d or c) to select the alarm
output for the communications line.
•
ON: The alarm signal is output to the communications line.
•
OFF: The alarm signal is not output to the communications line.