Pioneer avic-d1 Service Manual page 214

Hide thumbs Also See for avic-d1:
Table of Contents

Advertisement

1
6. GPS Self check
A
B
• GPS receiving status will be displayed.
• Conditions to move on to the next inspection.
Antenna connection is OK.
Data is received from one or more satellite.
Time is being displayed.
• When all the conditions are met, the background color will change to blue.
• Only when all the conditions are met, you can move on to the next inspection by the [ ] key on the remote
controller.
It should be noted, however, that you will not be able to move on to the next inspection if there is an error
(background color is red) even if the conditions are met.
C
<Supplemental explanation regarding error display>
Displayed message
No connection to DRAGON
Command error
Invalid data
D
7. Software version
E
• It indicates the version information of the software.
• Conditions to more on to the next inspection.
"GPS model" is "05UC DVD".
"Calibration check" is "OK". OK : "Setup touch panel effective range" in Testmode is done.
• Only when all the conditions are met, you can move on to the next inspection by the [ ] key on the remote
controller.
F
It should be noted, however, that you will not be able to move on to the next inspection if there is an error
(background color is red) even if the conditions are met.
214
1
2
6. GPS Self check
Using satellites NO.
01 02 03 04 05 06 07 08
Antenna connection
Receiving signal level
Latitude
Longitude
[joy stick down] It progresses to the next inspection.
Details of the error
This is an error when communication with DRAGON is not established.
Communication error due to a hardware problem could be the cause.
It is highly possible that the hardware on the DRAGON side is defective.
Time out error for response to BIOS call.
Communication error due to a hardware problem could be the cause.
It is highly possible that the hardware on the DRAGON side is defective.
This is an error when request is made while the data for response is not
prepared (not obtained from DRAGON).
Communication error due to a hardware problem could be the cause.
It is highly possible that the hardware on the DRAGON side is defective.
7. Software version
System boot / OS version
Syscom version
Monitor ucom version
Drive apl version
GPS program version
GPS model
Calibration check
[joy stick down] It progresses to the next inspection.
AVIC-D1/UC
2
3
2004/11/24 15:00:00
OK
13.5
3D 35 55 47.1
139 28 30.0
0.17 / 0.17
6.10
6.01
ver
4032
5.08 04/04/01 4.10
05UC
DVD (0x29)
OK
3
4
4

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents