Pioneer avic-d1 Service Manual page 207

5
• Display data (Error code)
: Overrun error (Communication error)
E0000000
: Framing error (Communication error)
E0010000
: Writing, setting error (An error has occurred at the time of setting M62 CRAM, a command, etc.)
E0020000
: Parameter error (Set parameter is invalid.)
E0030000
: Command error (Set command is invalid.)
E0040000
: Command uncompleted
E0060000
: Decode normally completed (Decode has been normally completed from the specified ID to the final
E0100000
target ID in EDC mode.)
: Hard reset or soft reset
E0FFFF00
The followings are valid only during error rate measurement or in EDC mode
: Media Load or Eject Failed (Mechanical error)
E0015300
: High Temperature (High temperature sense)
E0018000
: Voltage Out of Range (VD power supply failure)
E0018100
: Medium Not Present (No disc)
E0023A00
: No Seek Complete (Seek failure)
E0030200
: Unrecovered Read Error (Formatter Error, CRC (EDC) Error, Uncorrectable Error, etc.)
E0031100
: Track Following Error (Servo failure)
E0030900
In case that the above error codes cannot be obtained, ATAPI BIOS error code will be displayed.
[ATAPI BIOS error code]
Error code name
NO_ERROR 00000000H
ERR_ATAPI_RSV
ffff1000H
ERR_ATAPI_DNR ffff1001H
ERR_ATAPI_ANF ffff1002H
ERR_ATAPI_HEAT
ffff1003H
ERR_ATAPI_MECHA ffff1004H
ERR_ATAPI_NODISC
ffff1005H
ERR_ATAPI_PARAM
ffff1006H
ERR_ATAPI_REENT
ffff1007H
ERR_ATAPI_DISC
ffff1008H
ERR_ATAPI_TMOUT ffff1009H
ERR_ATAPI_DATA ffff100aH
ERR_ATAPI_EJECT
ffff100bH
ERR_ATAPI_DCHG
ffff100cH
ERR_ATAPI_MODE
ffff100dH
ERR_ATAPI_OFF
ffff100eH
ERR_ATAPI _TEST ffff100fH
5
6
Return value
Completed
Reserved
Device has not been prepared.
Device has not completed TOC search, etc.
The target address has not been found.
The device temperature is out of operational range.
Device cannot be operated because of any mechanical reason.
Device has not been found on ATAPI bus.
Disc has not been found.
An error has been found in parameter or command.
A reentrant prohibition violation has occurred.
Disc error
A command for data has been issued to an audio track.
Access to an unreadable disc such as reversely inserted disc.
Time out
No response from device for a certain period of time.
Error cannot have been corrected.
Disc has been ejected.
Disc change history exists.
Disc change has been executed since the last command.
X-3055 mode error
A command for test mode has been issued in Normal mode, or other
way round.
ATAPI BIOS is OFF.
An error has occurred with ATAPI_TEST command.
AVIC-D1/UC
6
7
Description
7
8
A
B
C
D
E
F
207
8