Denon AVR-1911 Owner's Manual page 12

Step 3
Calculating
10
2Q WKH VFUHHQ XVH ui
Step 2
WR VHOHFW ³&DOFXODWH´ DQG WKHQ SUHVV

ENTER
Measuring results are analyzed, and the
frequency response of each speaker in the
listening room is determined.
Step3:Calculating
MultEQ
Calculating
Please wait...
[ --------]
• Analysis takes several minutes to complete. The
time required for this analysis depends on the
number of speakers connected.
The more connected speakers there are, the
longer it takes to perform analysis.
Remote control operation
buttons
Step 4
Check
11
ui
8VH WR VHOHFW WKH LWHP \RX ZDQW
WR FKHFN DQG WKHQ SUHVV 
ENTER
Step4:Check
MultEQ
Please check the results
of the measured item.
Speaker Config.Check
Distance Check
Channel Level Check
Crossover Freq.Check
Next
[ENT]:Select
• Subwoofers may measure a greater reported
distance than the actual distance due to added
electrical delay common in subwoofers.
• If you want to check another item, press
RETURN
.
12
ui
8VH WR VHOHFW ³1H[W´ DQG WKHQ
SUHVV 
ENTER
NOTE
• If the result differs from the actual connection
status, or if "Caution!" is displayed, see "Error
messages" (vpage 10). Then carry out Audyssey
Auto Setup again.
• If the result still differs from the actual connection
status after remeasurement or the error message
still appears, it is possible that the speakers
are not connected properly. Turn this unit off,
check the speaker connections and repeat the
measurement process from the beginning.
• If you change speaker positions or orientation,
perform Audyssey Auto Setup again to find the
optimal equalizer settings.
Move the cursor
(Up/Down/Left/Right)
Step 5
Store
13
ui
8VH WR VHOHFW ³6WRUH´ DQG WKHQ
SUHVV 
ENTER
Save the measurement results.
Step5:Store
MultEQ
Please select "Store"
to store measurement
values.
Store
Cancel
[ENT]:Store
Step5:Store
MultEQ
Storing
Please wait...
[ ---------]
• Saving the results requires about 10 seconds.
• If you do not want to save the measurement
results, use ui to select "Cancel", then select
"Yes" using o p. All the measured Audyssey
Auto Setup data will be erased.
NOTE
During saving of measurement results, be sure
not to turn off the power.
Confirm the setting
ENGLISH
Set up speakers (Audyssey ® Auto Setup)
Finish
14
8QSOXJ WKH VHWXS PLFURSKRQH IURP
WKH XQLW¶V 6(783 0,& MDFN
15
6HW '\QDPLF 9ROXPHŒ
Finish
MultEQ
Storing complete.
Auto Setup is now
finished.
Turn on Dynamic Volume?
Yes : No
[ ]:Select [ENT]:Exit
• For details of Dynamic Volume settings, see
page 52.
n When turning Dynamic Volume on
• Use o to select "Yes", and then press ENTER
The unit automatically enters "Evening" mode.
n When turning Dynamic Volume off
• Use p to select "No", and then press ENTER
NOTE
After performing Audyssey Auto Setup, do not
change the speaker connections or subwoofer
volume. In event of a change, perform Audyssey
Auto Setup again.
Return to previous menu
.
.
9