Danfoss TS715 Installation & User's Instructions page 13

Before you change the preset programmes
Your installer will have set your unit to operate in one of the
following modes:
● 5/2 day - one set of programmes for weekdays and
another for weekends (page 14-15)
● 7 day - different settings for each day of the week
(page 16-17)
● 24 hour - one set of programmes for the whole week
(page 18)
!
See INSTALLER SETTING tick box
on inside fl ap label to ascertain which
mode your unit is set .
Please Note
The unit must be programmed in sequence and ON/
OFF times cannot be set out of sequence.
If you want to leave a preset time as it is, simply press
NEXT to move on to the next setting
Your installer will have set your unit to programme
either 2 or 3 ON/OFFs per day. If your clock has been
installed to allow 3 ON/OFFs and you do not wish to
use one of the ON/OFF settings, simply programme
the ON time to be the same as the OFF time and the
setting will not operate.
!
If at any time you get confused and need to reset
your timings to the standard programme, press the
RESET button to return to the preset programmes.
INSTALLER SETTING
24 Hour
5+2 Day
7 Day
13