What To Do When Encountering Problems In The Basic Shooting Operations - Panasonic AW-HE100E Operating Instructions Manual

What to do when encountering problems in the basic shooting operations

If the trouble is not resolved by taking the action suggested below, refer to "Troubleshooting" (page 55).
When performing the operations using the
accessory wireless remote control
The unit does not move.
 Press the [CAM1], [CAM2], [CAM3] or [CAM4] button to
select the unit which is to be operated.
If only one unit is being used, it is normally selected using
the [CAM1] button.
 If the unit's status display lamp is off or lights up orange, it
means that the unit's power is not on.
Refer to "How to turn the power on and off" (page 15),
and turn on the power.
 If the unit's status display lamp does not blink even
when the wireless remote control is operated near the
unit's wireless remote control signal light-sensing area, it
means that the wireless remote control's batteries have
run down.
Replace the batteries.
Multiple colour bands (colour bars) are
displayed.
Press the [MODE] button to switch to the camera picture.
The menu screen is displayed.
Press the [MENU] button for two seconds to exit the menu.
The lens focus is not adjusted automatically.
Press the [A/FOCUS] button to switch to auto focusing.
The camera picture is too light or too dark.
1. Press the [A/IRIS] button to switch automatically to the
lens iris adjustment.
2. Press the [AUTO] button of [GAIN] to switch automatically
to the gain adjustment.
Something is wrong with the colouring of the
camera pictures.
Refer to "Auto tracking white adjustment (ATW)" (page 31),
and switch to "ATW".
When performing the operations
using the controller
The unit does not move.
 Select the unit to be operated by following the procedure
below.
When the AW-RP655 is connected:
Press the [1], [2], [3], [4] or [5] button of [CONTROL/
PREVIEW MONITOR OUT SEL].
When the AW-RP555 is connected:
Press the [1], [2], [3], [4] or [5] button of [CONTROL].
When the AW-RP400/AW-CB400 is connected:
Press the [1], [2], [3], [4] or [5] button of [CONTROL
SELECT].
 If the [OPERATE] lamp on the controller is off, it means
that the power of the controller is not on.
 If the unit's status display lamp is off or lights up orange,
it means that the unit's power is not on. Refer to "How
to turn the power on and off" (page 15), and turn on the
power.
Multiple colour bands (colour bars) are
displayed.
Press the [MODE] button to switch to the camera picture.
The menu screen is displayed.
Press the [MENU] button to exit the menu.
The lens focus is not adjusted automatically.
Press the [EXT(AF)] button to switch to auto focusing.
The camera picture is too light or too dark.
1. Press the [IRIS] button several times to turn on its lamp,
and switch the lens iris adjustment to auto.
2. Press the [GAIN] button several times to turn on its lamp,
and switch the gain adjustment to auto.
When the AW-RP400 is connected, press the [AGC]
button on the AW-CB400.
Something is wrong with the colouring of the
camera pictures.
Refer to "Auto tracking white adjustment (ATW)" (page 31),
and switch to "ATW".
22 (E)