Quick Start - Mitsubishi DPSB70 User Manual

Quick Start

To attach the DiamondPoint monitor to your system, follow these
instructions:
1. Turn off the power to your computer.
2. If necessary, install the display card into your system. For more information,
refer to the display card manual.
3. For the PC: Connect the 15-pin mini D-SUB of the captive signal cable to the
connector of the display card in your system (Figure A.1). Tighten all screws.
For the Mac: Connect the DiamondPoint Macintosh cable adapter (not
included) to the monitor connector on the Macintosh (Figure B.1). Attach the
15-pin mini D-SUB end of the captive signal cable to the DiamondPoint
Macintosh cable adapter on the computer (Figure B.1). Tighten all screws.
NOTE: To obtain the DiamondPoint SB70 Macintosh cable adapter, call
NEC-Mitsubishi Electronics Display of America, Inc. at (800) 632-4662.
4. For download information on the Windows
for your DiamondPoint monitor, refer to the References section of this User's
Manual.
5. Connect one end of the power cord to the DimondPoint monitor and the other
end to the power outlet (Figure C.1).
6. Turn on the monitor (Figure D.1) and the computer.
NOTE: If you have any problems, please refer to the Troubleshooting section of
this User's Manual.
Figure A.1
15-pin
mini
D-SUB
Captive Signal Cable
DPSB70Manual.p65
® 95/98/Me/2000/XP INF file
Figure B.1
3
3
Mac Adapter
(Not Included)
Captive Signal Cable
5/7/02, 11:31 AM