Programmable Function Input Connections; Figure 4-16. Timing I/O Connections - National Instruments DAQ PCI-6023E User Manual

TRIG1
Source

Programmable Function Input Connections

© National Instruments Corporation
CONVERT*
Source
I/O Connector

Figure 4-16. Timing I/O Connections

There are a total of 13 internal timing signals that you can externally control
from the PFI pins. The source for each of these signals is
software-selectable from any of the PFIs when you want external control.
This flexible routing scheme reduces the need to change the physical
wiring to the board I/O connector for different applications requiring
alternative wiring.
You can individually enable each of the PFI pins to output a specific
internal timing signal. For example, if you need the CONVERT* signal as
an output on the I/O connector, software can turn on the output driver for
the PFI2/CONVERT* pin. Be careful not to drive a PFI signal externally
when it is configured as an output.
As an input, you can individually configure each PFI pin for edge or level
detection and for polarity selection, as well. You can use the polarity
selection for any of the 13 timing signals, but the edge or level detection
PFI0/TRIG1
PFI2/CONVERT*
4-31
Chapter 4 Signal Connections
DGND
PCI-6023E/6024E/6025E User Manual