Program Values - Bradford White RTG 199 MEN Installation And Operation Instructions Manual

Maintenance and service
7.5

Program values

This section describes details on programming the appliance. For most
applications the factory default values will provide robust and stable
operation. Only adjust the factory settings if the installation requires
changes as indicated in the appropriate section of this manual.
Program Description
P1 Maximum Power
P2 Minimum Power
P3 Remote
Controls installed
P4 Access to
Diagnostic Mode
P5 Cascade Mode
P6 Temperature Unit
P7 Gas type selection
P8 Back light
P9 Fan Purge
PH Cascading type
PC Primary/Secondary
mode
Table 37 Program values, factory default settings and ranges.
40
Refer to chapter 7.6 Control board diagnostics (page 41) regarding how
to access these P-modes.
Factory Default MIN
NG: 54, 21
LP: 46
7 7
_0 _0
E 0d
NO NO
°F °F
LP or NG
dE dE
IC IC
CS CS
CAUTION: Appliance malfunction!
▶ Misadjusted program values can lead to appliance
malfunction, errors, and service calls.
MAX
NG: 55, see chapter 4.14, page 32
LP: 49 note: reducing P1 values below maximum will
reduce maximum power of the appliance.
20 see chapter 4.3.8, page 22
6
10f see chapter 7.6, page 41
CC contact manufacturer for details
°C
Preset from factory.
Contact manufacturer for details.
On dE turns back light off after 60 seconds from
last button pushed, ON turns backlight on
Runs secondary fan and primary fan when P9
is selected by depressing the "P" - button
SC This menu is only available when cascade
mode is selected CC.
Contact manufacturer for details.
Cn
RTG 199 ME – 6 720 811 615 (2015/04)
Comment
Not available
permanently.