Advertisement
Turn On the Perimeter With No Delays
I have this feature.
I do not have this feature.
This feature requires a passcode.
COMMAND 2 is used to arm only the perimeter of your building, leaving
the interior of the building disarmed. This command allows no exit or entry
delay time through the perimeter, including the designated delay door.
Enter your personal passcode, plus ENT, to cancel COMMAND 2.
Remember there are no entry or exit delays when you use this function.
You must disarm (turn off) the system to enter or exit the premises.
Application
This arming command is useful in residential systems at night when
everyone is home and ready to retire for the evening.
In commercial installations, this arming command is useful when you are
working late and you want the perimeter of the building armed until you
are ready to leave.
COMMAND
2
Arming with COMMAND 2:
1. Ensure that all perimeter points are secure. Interior points are not
armed with this command, and may remain faulted while arming with
COMMAND 2. Perimeter point status lights should be off. If they're not,
see the section describing Force Arming the System.
2. Press the COMMAND bar. The Command Mode indicator light comes
on
3. Press the 2 key. The PERIMETER and INSTANT indicator lights come
on. This indicates that the perimeter points are armed without entry/exit
delay time.
4. To disarm your security system or cancel COMMAND 2, enter your
personal passcode and press ENT before the delay time expires.
11
Advertisement
