Dual Installation; Installation Requirements; Electrical Requirements - Wolf M Series Installation Manual

SPECIFICATIONS

Installation Requirements

The M series oven can be installed in a standard or flush
inset application. If a cooktop is being installed above an
oven, a minimum of 6 mm is required between units. Loca-
tion of the electrical supply within the oven opening may
require additional cabinet depth.
Finish the edges of the opening. They may be visible when
the door is open.
For standard installations, face trim will overlap stiles and
rails. Refer to the chart below.
For flush inset installations, a minimum 3 mm reveal is
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
INSTALLATION REQUIREMENTS
BASE SUPPORT
Single Oven
Double Oven
TRIM OVERLAP
Top
Bottom
Sides
WF Intl MOven IG 9002193B.indd 3

DUAL INSTALLATION

Two M series ovens can be installed side by side in a
standard or flush inset application. A dual installation kit is
required. To maintain appropriate airflow, the ovens must be
installed into one opening. Any cosmetic or structural mate-
rial placed between the ovens will impede airflow and is not
recommended. Refer to illustrations on the following pages.
The dual installation kit is available through an authorized
Wolf dealer.
MIN
115 kg
181 kg
25 mm
0 mm
18 mm
Electrical
Installation must comply with all applicable electrical codes
and be properly grounded (earthed).
Locate the electrical supply flush with the back wall and
within the shaded area shown in the illustrations on the
following pages. For ease of installation, the electrical
supply for the oven can be placed in an adjacent cabinet
within reach of the conduit.
Performance may be compromised if the electrical supply is
less than 220 volts.
The oven is supplied with a single phase and 3-phase
convertible power inlet box. The wiring diagram covering the
control circuit is provided with the oven.

ELECTRICAL REQUIREMENTS

SINGLE OVEN SINGLE PHASE 3-PHASE
Required Power Supply 220-240 V AC 380-415 V AC
50/60 Hz 50 Hz
Maximum Connected Load 5.4 kW TBD
Total Amps 22 TBD
DOUBLE OVEN SINGLE PHASE 3-PHASE
Required Power Supply 220-240 V AC 380-415 V AC
50/60 Hz 50 Hz
Maximum Connected Load 10.8 kW TBD
Total Amps 45 TBD
RATING
PLATE
Rating plate location.
|
wolfappliance.com 3
6/29/15 12:21 PM