Viking Professional & Designer 200 series Installation Manual page 10

Installation Procedure (cont'd.)
6a
Front Panel Attached
Front Panel Removed
Remove front panel to access the front leveling legs.
6b
Leveling legs will be raised during shipping. Adjust
front leveling legs down by using a 1/4 drive ratchet.
6a When the adjustment nut is visible, complete the Front Panel Attached
lowering of the legs from the top. When the legs are
down, tighten the locking nut on the top of the leg.
To level the dishwasher, take a level and use Step 6b to
adjust front legs to appropriate height. Use Step 5a to
adjust back leg to appropriate height. See Step 5b to
insure levelness from front to back. Adjust legs until the
rack is stationary. After unit is level, replace front panel
and insure that overflow channel is in place.
18
Front Panel Removed
Installation Procedure (cont'd.)
7
Attach screws through trim pieces
Install High Loop Clip, which is provided, a minimum of
into cabinets.
9
1.0"
(2.5 cm)
Cut here for 5/8"
(1.6 cm)
Cut here for 3/4"
(1.9 cm)
Identify discharge connection size; cut line to correct size
and connect. Clamp if necessary.
10B
(Standard discharge)
19
8
Minimum
20"
(50.8 cm)
from floor
20" (50.8 cm) from the floor.
10A
(Discharge with food waste disposer)