We recommend that you read this manual carefully to get the most out of your new unit. Thanks for selecting NADY AUDIO and the SPM-835 as your choice in powered mixers. WARNING ...3 FEATURES ... 4 INSTALLATION...
ATTENTION RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR IMPORTANT SAFETY INSTRUCTIONS When using this electronic device, basic precautions should always be taken, including the following: Read all instructions before using the product. Do not use this product near water (e.g., near a bathtub, washbowl, kitchen sink, in a wet basement, or near a swimming pool, etc.).
An ultra-compact 35W/channel stereo powered mixer offering top audio performance and exceptional flexibility – perfect for many small venue live sound reinforcement applications. • Full frequency response, and low noise with a wide dynam- ic range assures natural transparent audio •...
Parts of the unit can become very warm during use. This is normal during operation. Care should be taken to ensure that there is enough space around the unit for cooling (at least 12” or 30cm). Do not place the SPM-835 on high temperature devices such as power amplifiers etc.
C O N T R O L S A N D C O N N E C T I O N S 1. MONO INPUT SECTION (1) MIC INPUT The Mic input is an electronically balanced XLR type designed to accept signals from any balanced low impedance (Low Z) microphone.
C O N T R O L S A N D C O N N E C T I O N S During rehearsals, experiment with the equalizer controls on various instruments, vocals and combinations of these mixed together to become familiar with various equalizer settings. (5) AUX ( POST ) SEND CONTROL The Aux send is mono and post-EQ and post-fader and the signal level sent to the AUX bus will be affected by the...
C O N T R O L S A N D C O N N E C T I O N S 3. MASTER SECTION a. AUX Send/Returns Function and Operation (24) STEREO AUX RETURNS (LEFT/MONO, RIGHT) (16) AUX RETURN CONTROL The Aux Return jacks are the mono or stereo returns for Aux Send (25).
C O N T R O L S A N D C O N N E C T I O N S (28) (27) (30) to narrow the stereo width of a reverb field. To do this you will have to come back on two mono channels to get independent pan for the left and right signals.
Allow 1 minute after powering up for the system to reach equilibrium before setting input gains and other levels. You can leave the SPM-835 on all the time. It is conservative- ly designed, so heat build up isn’t a problem even in 24-hour- a-day operation.
Page 16
DO NOT ATTEMPT TO SERVICE THIS UNIT YOURSELF AS IT CAN BE DANGEROUS AND ALSO WILL VOID THE WARRANTY. NADY SYSTEMS, INC. • 6701 SHELLMOUND STREET, EMERYVILLE, CA 94608 Tel: 510.652.2411 • Fax: 510.652.5075 • www.nadywireless.com...