This unit was developed using the expertise of professional sound engineers and working musicians. You will find that your new SPM-4250 has superior performance and greater flexibility than any other stereo powered mixer in its price range. Please read this manual carefully to get the most out of your new unit.
ATTENTION RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR IMPORTANT SAFETY INSTRUCTIONS When using this electronic device, basic precautions should always be taken, including the following: Read all instructions before using the product. Do not use this product near water (e.g., near a bathtub, washbowl, kitchen sink, in a wet basement, or near a swimming pool, etc.).
Parts of the unit can become very warm during use. This is normal during operation. Care should be taken to ensure that there is enough space around the unit for cooling. Also, do not place the SPM-4250 on high temperature devices such as power amplifiers, etc., or the unit may overheat in operation.
FRONT CONTROLS AND CONNECTIONS CHANNEL SECTION (1) MIC INPUT This electronically balanced XLR input is designed to accept signals from any balanced or unbalanced low impedance (Low Z) microphone. The XLR jack is configured for: Pin1 = ground, Pin2 = positive (+), Pin3 = negative (-).
Page 6
EFFECTS (7). Adjusting the PFL never affects the AUX SEND (18), RECORD OUT (20), or SPEAKER OUTPUTS (26). This is useful if the person operating the SPM-4250 wants to listen to one or more of the input signals, especially, to troubleshoot problems without affecting the main mix.
(19) AUX RETURN This input can be used to return the effected signal into the SPM-4250 or it can be used as an auxiliary input for line level devices. The input signal can be adjusted using the MASTER VOLUME (24) and the output volume of the external unit.
REAR CONTROLS AND CONNECTIONS (25) (29) (28) (27) (26) (25) PHANTOM POWER ON/OFF SWITCH When this switch is depressed, +48V of phantom power will be supplied to the XLR mic inputs. (26) SPEAKER OUTPUT JACKS The left and right 1/4" speaker outputs can deliver up to 125W RMS per side to 4Ω loads. (27) POWER CONNECTOR The IEC socket is used to connect the power cord to an AC power source.
Page 12
DO NOT ATTEMPT TO SERVICE THIS UNIT YOURSELF AS IT CAN BE DANGEROUS AND WILL ALSO VOID THE WARRANTY. NADY SYSTEMS, INC. • 6701 SHELLMOUND STREET, EMERYVILLE, CA 94608 Tel: 510.652.2411 • Fax: 510.652.5075 • www.nady.com...