This unit was developed using the expertise of professional sound engineers and working musicians. You will find that your new SPM-6300 has superior performance and greater flexibility than any other stereo powered mixers in its price range. Please read this manual carefully to get the most out of your new unit.
ATTENTION RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR IMPORTANT SAFETY INSTRUCTIONS When using this electronic device, basic precautions should always be taken, including the following: Read all instructions before using the product. Do not use this product near water (e.g., near a bathtub, washbowl, kitchen sink, in a wet basement, or near a swimming pool, etc.).
[Please note: Nady Systems is not responsible for shipping damage. If your unit is damaged, do not return to Nady, but notify your dealer and the shipping company (if shipped to you) immediately to make a claim. Such claims must be made by the consignee in a timely manner.]...
FRONT CONTROLS AND CONNECTIONS CHANNEL SECTION (1) MIC INPUT This electronically balanced XLR input is designed to accept signals from any balanced or unbalanced low impedance (Low Z) microphone. The XLR jack is configured for: Pin1 = ground, Pin2 = positive (+), Pin3 = negative (-). (2) LINE INPUT This 1/4"...
Page 6
FRONT CONTROLS AND CONNECTIONS (16) (12) (15) (14) (10) (11) (13) (17) (18)
Page 7
The audio mix is adjusted by the EFF control of each channel. The signal output is not effected by the internal reverb. The Effects Return input jack can be used to return the signal into the SPM-6300 or it can be used as another auxiliary input for line level devices.
If the mixer has been running constantly for several hours, make sure the rear panel is not getting too hot to avoid over-heating the unit and causing thermal runaway. If it is getting very hot, either turn the audio down some or let the SPM-6300 idle with no output signal and the fan on.
1. INPUT SECTION Input MONO CH MIC MONO CH LINE AUX INPUT EFFECTS RETURN TAPE IN 2. OUTPUT SECTION Power Output 8Ω Both Channels Driven (1% THD)..105W RMS per side 4Ω Both Channels Driven (1% THD)..150W RMS per side Frequency Response...
Page 12
DO NOT ATTEMPT TO SERVICE THIS UNIT YOURSELF AS IT CAN BE DANGEROUS AND WILL ALSO VOID THE WARRANTY. NADY SYSTEMS, INC. • 6701 SHELLMOUND STREET, EMERYVILLE, CA 94608 Tel: 510.652.2411 • Fax: 510.652.5075 • www.nady.com...