Operations; Before Use; Playback; Turning The Power Off - Denon PMA-2020AE Owner's Manual

Operations

Before use

1
Turn the VOLUME on the main unit all the way down.
2
Set SOURCE DIRECT on the main unit to "
3
BASS TREBLE BALANCE
Set , and
to the center positions.
4
X
Press on the main unit.
The power indicator blinks red for several seconds, then lights
green.

Turning the power off

1
AMPLIFIER X
Press .
The power is set to the standby mode.
2
X
Press on the main unit.
The power indicator turns off, and so does the power.
NOTE
Power continues to be supplied to some of the circuitry even when the
power is in the standby mode. When leaving home for long periods
of time or when going on vacation, either press
turn off the power, or unplug the power cord from the power outlet.
Starting playback
1
Use INPUT SELECT
source to be played.
• The input indicator on the main unit for
j OFF".
the selected source lights.
[Selectable source]
on the main unit
RECORDER-2 RECORDER-1
PHONO CD
AUX NETWORK
2
Play the selected source.
3
VOLUME df
Adjust
4
Adjust the tone with
on the main unit.
VOLUME
• When on the main unit is turned just past the "12
o'clock" position (over halfway), the effect of
on the main unit adjustments decreases.
VOLUME
• When on the main unit is turned to maximum or all the
way clockwise, the bases and treble can no longer be adjusted.
5
If there is no need to adjust the tone, press
DIRECT
on the main unit.
X
on the main unit to
• When switched "hON", the signal does not pass through the
tone adjustment circuitry (bass, treble and balance), resulting in
playback of a higher sound quality.
• When set to "jOFF", the sound can be adjusted to suit your
taste.
6
MUTING
Press
The power indicator on the main unit blinks red.
• Press again for sound.
to select the
TUNER
to the desired level.
BASS TREBLE BALANCE
, and
BASS TREBLE
and
SOURCE
to mute the sound.
9
You can also use the following operation to select an input
source.
n Select the input source using the main unit
INPUT SELECTOR
Turn .
INPUT SELECTOR
• Turning switches the input source, as shown
below.
RECORDER-2 RECORDER-1
NETWORK AUX TUNER
n Play back devices connected to power amplifier
direct connectors
POWER AMP DIRECT
Press on the main unit.
h
• By switching this " ON", it is possible to play back a device
connected to the Power Amp Direct connector on the rear panel.
In this case, the input indicator is turned off.
j
• By switching it " OFF", it is possible to play back the program
INPUT SELECTOR
source selected using the
the input indicator lights up.
PHONO
CD
knob. In this case,