Placing Paper In Drawers - Toshiba E-studio 207L Operation Manual

1.BEFORE USING EQUIPMENT
 Placing paper in drawers
Follow the procedure below to place paper in a drawer. For acceptable copy paper, see the following page:
 P.11 "Acceptable copy paper"
Turn the power of this equipment ON.
1
2 Pull out a drawer carefully until it comes to a stop.
Place paper in the drawer.
3
 Up to 600 sheets (64 g/m
one drawer. Be sure that the height of the stacked paper
does not exceed the line indicated inside of the side
guides.
 P.11 "Acceptable copy paper"
 Fan and jog the stack of paper well before you place it in
a drawer, or the sheets may not be separated before
being fed. Be careful not to cut your fingers when
fanning.
 Place paper with its copy side up. The copy side may be
noted on its wrapping paper.
Move the end guide to the trailing edge of the paper
4
while pushing its lower part in the direction of the
arrows.
While holding the green lever of the front side guide,
5
adjust the side guides to the paper size.
Adjust the side guides with both hands.
2
) (17 lb. Bond) can be placed in
1 BEFORE USING EQUIPMENT
Placing Paper 13