Adf -> Sadf - Toshiba E-studio 207L Operation Manual

4 EDITING FUNCTIONS
ADF -> SADF
You can switch the feeding mode when the RADF (Reversing Automatic Document Feeder, optional) is used,
from "ADF" to "SADF". The paper feeding mode has 2 types as follows:
ADF (Continuous feed mode): Feeds originals continuously when you press the [START] button on the
control panel while originals are being placed on the RADF (optional). This is useful when you make more
than one copy in one operation. (Default setting)
SADF (Single feed mode): Feeds originals one by one automatically. This is useful when you usually only
have 1 original.
When the single feed mode (SADF) is set, place originals one sheet at a time. If you place more than one
original, the copied image may be skewed or the originals may misfeed.
Place paper in the drawer(s).
1
Press [ADF -> SADF] on the EDIT menu.
2
Press [OK].
3
The feeding mode is now set at "single feed mode".
4 Select other copy modes as required.
5 Place the original(s) on the RADF (optional) one sheet at a time.
The original is pulled into the RADF (optional) automatically, and then the menu below appears.
Repeat step 5 if you have another original. The placed original will be pulled into the RADF (optional)
automatically even if you do not press [NEXT COPY] on the touch panel.
When the scanning of all the originals is finished, press [JOB FINISH].
6
If you want to stop copying, press [JOB CANCEL].
122 ADF -> SADF