Setting Up; Inserting The Needle - Pfaff 521 Instruction Manual

9

Setting up

9

Inserting the needle

.01
1
Fig. 9 - 01
All regulations and instructions in this Instruction Manual are to be observed!
Special attention is to be paid to the safety regulations!
All setting up work is only to be carried out by appropriately trained personnel.
Before all setting up work, the machine is to be separated from the electricity
supply by removing the plug from the mains or switching off the On/Off
switch!
2
3
The choice of needle depends on the model of the machine and the thread and
material used, see Chapter 3.02 Needles and threads for the PFAFF 521 or
3.03 Needles and threads for the PFAFF 1521.
Switch the machine off!
Danger of injury if the machine
is started accidentally!
PFAFF 521:
Only use needles of system 134.
PFAFF 1521:
Only use needles of system 134-35.
Raise roller presser 1.
Pull roller presser 1 downwards slightly
and swing it out to the left.
Loosen screw 2 and insert needle 3 until
you feel it stop. The long groove must be
facing the left.
Tighten screw 2 and swing the roller
presser back.
Setting up
9 - 1