Table of Contents
Advertisement
Start automatic operation (TM mode)
When TM is selected on the display and
the programmed heating time begins the
control starts the heating operation.
The following flashing indications appear
alternately on the display:
ST
TM
21
65
"TM" indicates automatic operation.
On completion of the start phase the follo-
wing appears continuously on the display
TM
65
Generally the pre-programmed heating
output (PS, PE) is adopted. If however you
want to change the current value, then this
can be done by pressing the "+" or "-" keys
in 5% steps. The changed value appears on
the display. The program adopts the new
value for the control until the completion
of the current heating window. On starting
the following heating time the programm-
ed value is re-used. A permanent change of
heating output can only be achieved by
programming PS and PE.
Note:
The pre-heating program runs automatically and
can be stopped by changing ("ENTER" key) the
operating state to "SB". In this case the out of
operation mode (alternating indication "Ex", see
below) runs through to the end.
If the stove is disconnected from the mains
supply (i.e. power cut) during the start phase and
then re-connected to the mains supply, the start
phases starts from the beginning again.
PLACE STOVE OUT OF OPERATION
Switching off from "Manual operation"
(ON)
If the "ON/OFF" key is pressed during ope-
ration then the switch off program is acti-
vated. The following alternating flashing
indictors appear on the display:
ON
Ex
65
60
"Ex" Exit phase 1
The number below is the remaining time in
seconds for this phase.
On completion of Exit phase 1 the display
shows (flashing):
ON
CL
65
120
"CL" Cleaning phase
The number below is the remaining time in
seconds for this phase.
On completion of Exit phase 1 the display
shows (flashing):
ON
Ex
65
301
"Ex" Exit phase 2
The number below is the remaining time in
seconds for this phase.
Note:
The full switching off process lasts for about 8
minutes and cannot be interrupted by the user.
On confirmation of "ON/OFF" the switch off
program is initialised.
21
Advertisement
Table of Contents
