To Adjust The Copy Image Quality In The Auto Color Mode; Text/Photo - Toshiba e-STUDIO 2500c Manual

2. Copier-specific Adjustments

2.1.3 To Adjust the Copy Image Quality in the Auto Color Mode

* You can start with any of the procedures. But it is recommended to perform the procedures in order, as listed
below. You can use one procedure in conjunction with another. But if this changes the image quality more
than required or loses the effectiveness of the adjustment, restore the settings made in the previously used
procedure to the original ones. Then use other procedures.
* Both the service technician and the user can use procedures (1) and (2).
* Only the service technician must use procedure (3).
(1) Press the [BASIC] button on the Control Panel. Press the [
After increasing the copy density, copy and check the copy image quality.
With the copy density set to the maximum, if further image quality adjustments are still necessary, use the
next procedure.
(2) Press the [IMAGE] button on the Control Panel. Press the [SHARPNESS] button.
Press the [SHARP] button to increase the sharpness intensity.
After increasing the sharpness intensity, copy and check the copy image quality.
With the sharpness intensity set to the maximum, if further image quality adjustments are still necessary, the
service technician must use the following procedure.
(3) Enter adjustment mode [05]. Increase the value for code [1757] to strengthen the copy density of text (or
increase the sharpness intensity).
• The sharpness intensity can be adjusted only when the "TEXT/PHOTO" mode is selected from among the
Auto Color original mode options in adjustment mode [05]. Set a value larger than "128" for code 05-
1757.
Original mode

Text/Photo

* Setting "0" provides the softest image, while setting "255" provides the sharpest image.
Changing the value for this code will change the sharpness intensity, when the "Sharpness" indicator in the
"IMAGE" menu is set to the center. Remember that 1 step of the indicator will increase or decrease the
sharpness intensity by 25. If the sharpness intensity of the center value is changed, each step of the indicator
will be changed accordingly. (For instance, if the center value is increased by 25 (sharper), the value of each
step of the indicator will also be increased by 25 (sharper).)
2.1
e-STUDIO2500c/3500c/3510c
[05] code Recommended value
05-1757 Set a value larger than 128.
] button to increase the copy density.
Acceptable value range
0 to 255
Default
128