Toshiba e-STUDIO 2500c Manual page 168

3. Printer-specific Adjustments
PCL6 PS3
(1) Enter adjustment mode [05]. Change the value to adjust the image density in the toner save mode.
* The [05] code to use varies, depending on whether to adjust the image quality on Full Color or Twin Color
printing or on Black and White printing. Use either of the procedures below corresponding to the type of
original to print.
To adjust the image quality in Full Color or Twin Color printing
("Auto," "Color" or "Twin Color" is selected from among the "Color" options on the PCL6 or PS3 printer
driver. "Auto," "Color" or "Twin Color" is selected from among the "Color Type" options on Macintosh.)
* The "Color" options are available in the "Basic" tab on the PCL6 and PS3 printer drivers. The "Color
Type" options are available in the "Color Settings 1" menu in the print dialog box on Macintosh.
(a) Enter adjustment mode [05]. Change the value for code [1055] or [1057] to adjust the upper limit of the
image density in the toner save mode.
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
PDL
PS3
PCL6
* Set the value in increments of approximately 10, while checking the printouts until the optimum value
is obtained.
3.18
e-STUDIO2500c/3500c/3510c
Mac
[05] code Recommended value
Set a value smaller than 176 to
05-1055
decrease the density.
Set a value larger than 176 to
05-1057
increase the density.
Acceptable
Default
value range
0 to 255 176