Kinds Of Adjustment In Play Mode; Head Switching Point - Samsung SCL700 Service Manual

Alignment and Adjustment
4-3-3 Adjustment

1. Kinds of adjustment in PLAY mode.

ADDRESS NAME
HD SWP
061
32. 768 KHZ CLOCK
062
MODEL CODE
063
D.ZOOM SIZE
064
TBC DEFAULT
065
2. Adjustment
* Please keep the order according to explanation.
2-1. Setting of the model code0
a. Preparation
TAPE NONE
EQUIPMENT POWER SOURCE
OTHER NONE
TEST POINT NONE
ADDRESS 063
NAME MODEL CODE0
b. Connect a power source.
c. Get into the VCR adjustment mode.
d. Press the "BLC(MODE UP)" or
"FADE(MODE DOWN)" button of
Camcorder so as to select the address 063.
e. Press the "DSE(DATA DOWN)/P.AE(DATA
UP)" so that OSD shows" "ERR:XX EVR: XX"
"XX" is different dependent on the model as
below.
MODEL NAME
SCL700
SCL710
NTSC
SCL750
SCL770
VP-L700
VP-L700U
PAL
VP-L710
VP-L750
VP-L750D
VP-L770
f. Be sure to press the "ENTER(CONFIRM)" but-
ton on Camcorder to memorize setting.
g. Reset the power source so as to fix the new
data to the Camcorder's EEPROM.
4-42
NORMAL MODEL
NTSC
05
ADDRESSED CODE
80
81
85
87
80
8A
81
85
86
87
PAL NTSC
Adjustment
1C
Model code setting
88, 99 (for the VP-L750D)
05
01

2-2. Head Switching Point

: This adjustment is performed after the
replacement of deck mechanism.
• Without this adjustment, there will be a noise
in playback picture.
a. Preparations
STANDARD COLOR BAR TAPE
RECORDED WITH SP SPEED
TAPE
*NTSC
EQUIPMENT POWER SOURCE
OTHER NONE
TEST POINT NONE
ADDRESS 061
NAME HD SWP
b. Connect a power source.
c. Get into the VCR adjustment mode.
d. Press the "BLC(MODE UP)" or "FADE(MODE
DOWN)" button of Camcorder so as to select
the address 061.
e. Insert the Standard Color Bar Tape and press
the "PLAY" button.
Note : If there is no video out, when you pressed
the "PLAY" button, you can not adjust the
Head Switching Point.
It may be caused by maladjusted VIDEO
block.
In this case, adjust the VIDEO block before
the Head Switching Point.
HI 8 MODEL
PAL
01
Samsung Electronics