Daikin FHY35BJV1 Installation Manual page 19

Connection of wiring between units and for the remote control cord (Refer to Fig. 27)
• Wiring between units
Holding the control box lid, loosen the two securing screws, remove the control box lid, match up the phases
on the power source terminal block inside (3P), and make the connections.
After this is done, use the attached clamp (4) to bind wiring between units to the anchor point.
(Refer to Fig. 28)
• Remote controller cord: The simultaneous operation multi sub-unit is not required. (Refer to Fig. 27.29)
Connect to the remote control terminal block (2P). (There is no polarity.) After this is done, use the attached
clamp (4) to bind remote controller cord to the anchor point. (Refer to Fig. 28)
Attaching the suction grille and the dressing boards
• Once wiring is complete, firmly attach the dressing side board by reversing the steps taken to remove the
suction grille.
Fig. 27
Remote control terminal block (2P)
Control box
Control box lid fixation
screw
Fig. 28
Fastener
Wiring between
units
Clamp (4)
(attached)
Fastener
English
Power supply terminal block (3P)
Ground terminal
Remote controller cord
Clamp (4) (attached)
After securing the
clamp material
to the bracket,
cut off any extra
material.
Remote controller cord
Fig. 28
Rear penetration lid
Conduits
Wiring between units
Wiring between units (If wiring the slave
unit, connect to master unit)
How to connect power supply terminal
block (3P)
Fig. 29
Remote control
terminal block (2P)
Remote controller cord
Seal with caulking
material or putty
Liquid pipe
Gas pipe
Drain hose
17