Windsor SC20 10052190 Operating Instructions Manual page 25

On-board Charger Battery Selection
Disconnect charger from wall outlet before
changing charge profiles. Failing to do so could
result in electrical shock.
Débrancher le chargeur de la prise murale avant de
modifier les profils de charge. Le non-respect de
cette consigne pourrait provoquer une décharge
électrique.
DIPSWITCH: SW1
Charging Curve Table
DP1 DP2
IUIa-ACD-for Wet batteries (default
ON OFF
setting)
IUIa-O AGM-for AGM or Gel batteries
ON ON
(maintenance free)
Dipswitches are located behind
the label on the front of the
charger. Peel the top right
corner back to reveal two sets
of dipswitches.
CHARGING CURVE
86400640 Operator's Manual - Saber Compact 20
Only dipswitch SW1 effects the charging curve. Select
the appropriate dip switch setting from the Charging
Curve Table. Do not change settings of SW2. Changing
settings of SW2 dipswitch could result in charger
failure.
Once the appropriate charger setting has been
selected, replace label. To verify charger settings,
observe charger immediately after startup. When
configured for lead-acid batteries, the red LED will flash
twice. If configured for gel/AGM batteries the green
LED will flash twice.
Maintenance
25