To Adjust Squeegee Pitch; To Adjust Amount Of Rear Squeegee Deflection; To Replace Or Rotate Front Squeegee Blade; Greasing Axles - Windsor SC20 10052190 Operating Instructions Manual

To Adjust Squeegee Pitch

1. Choose a smooth, level surface. Turn "ON" the key
switch and vacuum switch. Lower the squeegee
and drive forward at least 2 feet (60cm.).
2. With the squeegee down, stop the machine. Do not
allow machine to roll back.
FOR SAFETY: Before leaving or servicing the
machine, stop on level surface, turn off machine
and remove key.
3. Determine the differences, if any, in deflection of
the squeegee blade between each end and the
middle. Proper adjustment is obtained when
deflection is equal all the way across the squeegee
blade.
4. To decrease the deflection of the squeegee blade
at the ends, adjust plastic knobs at the far right or
left of squeegee assembly.
5. Check the deflection of the squeegee blades
again. Repeat steps 1 through 4 until the deflection
is equal across the entire rear squeegee blade.
To Adjust Amount Of Rear Squeegee
Deflection
1. Choose a smooth, level surface. Turn "ON" the key
switch and vacuum switch. Lower the squeegee
and drive forward at least 2 feet (60cm.).
2. With the squeegee down, stop the machine. Do not
allow machine to roll back.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, turn off machine
and remove key.
3. Observe the amount of squeegee deflection. It
should deflect approximately 3/8 in. (9.5mm)
across the entire width of the squeegee.
4. To increase the squeegee deflection, turn the
center knob above the lift carrier bracket clockwise.
To decrease the deflection, turn the knob counter-
clockwise.
NOTE: The deflection should be consistent along the
length of the squeegee. If the deflection varies from
end to end the knobs can be adjusted independently
to correct the variation.
5. Turn on the key switch. Raise, then lower
squeegee assembly. Drive forward at least 2 feet
(60cm).
6. Repeat steps 2 through 4 until deflection of approx-
imately 3/8 in. (9.5mm) is reached
86400640 Operator's Manual - Saber Compact 20
To Replace Or Rotate Rear Squeegee
Blade
1. With the squeegee in the up position, turn key
switch "OFF".
FOR SAFETY: Before leaving or servicing
machine; stop on level surface, turn off machine
and remove key.
2. Remove the squeegee assembly from the
machine. Unlatch and remove blade retainer strap
and remove squeegee blade.
3. Rotate the squeegee to new edge position or
replace as required. Each blade has four edge
positions.
4. Install blade on locating tabs of squeegee
assembly.
5. Install squeegee retainer strap.
6. Fasten and lock latch, adjust latch only tight
enough to take up slack in retaining strap.
To Replace Or Rotate Front Squeegee
Blade
1. With the squeegee in the up position, turn key
switch "OFF".
2. Remove the squeegee from the machine. Loosen
(3) thumb screws securing retainer strap.
3. Remove front retainer strap.
4. Remove squeegees blade from locating tabs on
squeegee assembly and rotate to new position or
replace as required.
5. Install blade on locating tabs of squeegee tool.
6. Replace front retainer strap.
7. Secure strap by tighten (3) thumb screws.

Greasing Axles

1. Apply 1-2 strokes of MOBILETEMP®78 or compat-
ible clay-based or calcium-based grease per
service schedule.
Maintenance
29