Operation / Maintenance - Napoleon BGD36CFNTR Installation And Operating Instructions Manual

OPERATION / MAINTENANCE

Purge all gas lines with the glass door of the fi replace
removed or opened. Assure that a continuous gas fl ow
is at the burner before installing the door.
When lit for the fi rst time, the fi replace will emit a slight
odour for a few hours. This is a normal temporary con-
dition caused by the "burn-in" of internal paints and
lubricants used in the manufacturing process and will
not occur again.
FOR YOUR SAFETY READ BEFORE LIGHTING:
A. This fi replace is equipped with a pilot which must be lit
by hand while following these instructions exactly.
B. Before operating smell all around the fi replace area for
gas and next to the fl oor because some gas is heavier
than air and will settle on the fl oor.
C. Use only your hand to turn the gas control knob. Never
use tools. If the knob will not turn by hand, do not try to
repair it. Call a qualifi ed service technician. Force or at-
tempted repair may result in a fi re or explosion.
D. Do not use this fi replace if any part has been under water.
Immediately call a qualifi ed service technician to inspect
the fi replace and replace any part of the control system
and any gas control which has been under water.
WARNING: The gas valve has an interlock device which
will not allow the pilot burner to be lit until the thermocouple
has cooled. Allow approximately 60 seconds for the ther-
mocouple to cool.
When lighting and re-lighting, the gas knob cannot be turned
from pilot to off unless the knob is depressed slightly.
1. Stop! Read the above safety information on this label.
2. Turn off all electric power to the fi replace.
3. Turn the gas knob clockwise to off.
4. Wait fi ve (5) minutes to clear out any gas. If you smell
gas including near the fl oor. Stop! Follow "B" in the above
safety information on this label. If you don't smell gas go the
next step.
1. Turn off all electric power to the fi replace if service is to
be performed.
TURN THE CONTROL VALVE TO THE OFF POSITION WHEN HEATER IS NOT IN USE.
After extended periods of non-operation such as follow-
ing a vacation or a warm weather season, the fi replace
may emit a slight odour for a few hours. This is caused
by dust particles in the heat exchanger burning off. In
both cases, open a window to suffi ciently ventilate the
room.
• Turn off all gas to the fi replace.
• Open windows.
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone
in your building.
• Immediately call your gas supplier from a neighbour's
phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fi re de-
partment.
LIGHTING INSTRUCTIONS
5. Turn gas knob counter-clockwise to pilot.
6. Depress slightly and hold gas knob while lighting the
pilot with the push button ignitor. Keep knob depressed for
one minute, then release. If pilot does not continue to burn,
repeat steps 3 through 5.
7. With pilot lit, depress and turn gas knob counter-clock-
wise to on.
8. If equipped with remote on-off switch/thermostat, main
burner may not come on when you turn valve to on. Remote
switch must be in the on position to ignite burner.
9. Turn on all electric power to the fi replace.
TO TURN OFF GAS
2. Push in gas control knob slightly and turn clockwise to
off. Do not force.
WHAT TO DO IF YOU SMELL GAS:
37
GAS KNOB
W415-0566 / E / 09.28.07