Napoleon BGD36CFNTR Installation And Operating Instructions Manual page 30

30
OPTIONAL CLEAN FACE SURROUND INSTALLATION BGD36CF ONLY
WAVE
S36WN
(BROWN)
S36WP
(PEWTER)
FIGURE 81
CLEAN FACE SURROUND MINIMUM
ENCLOSURE CLEARANCES
WARNING: Use only
non-combustible
material such as ce-
ment board, ceramic
tile, marble, etc.
when fi nishing to the
fi replace. DO NOT
USE WOOD.
FIGURE 84
FIGURE 85
NOTE:
** Installation requires a minimum amount of non-
combustible facing above the top of your fi replace.
Refer to Minimum Enclosure Clearances section to
verify if your unit has been installed with the proper
requirements for this kit.
W415-0566 / E / 09.28.07
CONVEX
S36CVN
(BROWN)
S36CVP
TER)
FIGURE 82
* *
(PEW-
OPTIONAL CLEAN FACE TRIM KIT
INSTALLATION
The "wave" clean face surround kit is shown in all
illustrations.
NOTE: THE OPTIONAL CLEAN FACE TRIM KIT MUST
BE INSTALLED BEFORE PROCEEDING.
1. From the rear side of the clean face front,
insert the weld studs on the top window
plate assembly upward through the
FIGURE 86
3. First secure the clean face surround to the fi replace
front by hooking the ledge that runs horizontally on the rear
surface of the clean face surround over the bottom edge of
the fi replace front opening. (FIGURE 87)
4. With the clean face surround against the fi replace front,
hook the surround clips in behind the top lip of the fi replace
front opening
(FIGURE 87)
provided through the slot in the surround clip and into the
pre-drilled hole in the clean face surround.
the optional clean face trim kit was
installed, the surround clip fi ts into
the cut out and is secured in the
same fashion.
(FIGURE 90)
FIGURE 87
CONCAVE
S36CCN
(BROWN)
S36CCP
(PEW-
TER)
FIGURE 83
holes on the underside of the
top section of the clean face
front. (FIGURE 86)
2. Using a socket
wrench, secure
using the nuts and
washers provided.
Depending on your
surround, space
may be tight.
(FIGURE 86)
and secure using the screws
(FIGURE 89)
FIGURE 88
FIGURE 89
FIGURE 90
If