Setting A Central Admin Server - Fujitsu N7100 Operator's Manual

4.9.2 Setting a Central Admin Server

Set whether to manage the scanner under central administration.
When [Central Admin] is enabled, the scanner is registered in the Central Admin Server
as a target for central administration.
1. Select [Scanner Central Admin Server] under [Network Admin].
 The [Scanner Central Admin Server] window appears.
2. Specify each item.
Automatic updates are applied to the scanner system (including the security and
installed options), system configuration, and Add-ins.
HINT
 If registration with the Central Admin Server is successful, the value for "This scanner's
server-side status is:" changes from "Unregistered" to "Registered".
Even when setting values are correct, if the network is disconnected or the Central
Admin Server is in a suspended state, registration will fail. In either case, if [Central
Admin] is [On], the process will be run again the next time the scanner is turned on or
resumed from the standby mode.
 For details about the settings required to use SSL for communication between the
Central Admin Server and scanner, refer to
111).
 When user roaming or job settings are enabled, if communication with the Central
Admin Server is not possible, a confirmation message will appear at login. If the [OK]
button is pressed, the settings saved in the scanner are used. Pressing the [Cancel]
button returns to the login window.
4.9 Configuring the Network Admin Settings
Touch
Panel
"4.9.1 Setting the Admin Connection" (page
112
Central Admin
Console