First Alert FA2000C Installation And Setup Manual page 33

PROMPT
Flashing Cursor
(system is ready for
entry of word).
 Z N 0 1 A
Flashing Cursor
 Z N 0 1 B A C K
 Z N 0 1
B A C K
A
Flashing Cursor if "6"
is pressed (system is
ready for next word).
 Z N 0 1
B A C K
D O O R
Flashing Cursor
 Z N 0 1
B A C K
D O O R A
Flashing Cursor if "6"
is pressed (system
ready for next word).
Summary Display
 Z N 0 1
B A C K
D O O R
P r o g r a m A l p h a ?
0 = N o , 1 = Y e s 0 0
A l p h a P g m
8 2
EXPLANATION
To delete or change the default descriptor for zone 1, press  plus the same zone number (01).
This will clear that descriptor and gain access to the entry mode with flashing cursor, allowing
changes to be made.
NOTE: If you do not wish to change the existing descriptor for zone 1, enter  plus the next
zone number for which you wish to enter (or check) a descriptor. A summary display for that
zone will appear. You must then press  plus the same zone number again to gain access to
the entry mode (flashing cursor) for that zone.
Press # plus 3-digit number for the first word from the "Alpha Vocabulary List". Example: The
descriptor that we wish to enter for zone 1 is BACK DOOR. From the list, BACK = 015.
Therefore, you would enter # 0 1 5.
NOTE: If you accidentally enter the wrong word, simply press # plus the correct 3-digit number
for the word you want.
Press "6" to accept the selected word and continue.
NOTE: If this is the only word you are using for the descriptor, press "8" instead of "6" to save
that word in memory. The system displays the summary screen.
Enter the 3-digit number for the next word. In our example, the word is DOOR, whose number is
"061".
Enter # 0 6 1. This display will appear:
Press "6" to accept the selected word.
NOTE: If these are the only words you are using for the descriptor, press "8" instead of "6" to
save them in memory.
The two words in our example have now been entered. Note, however, that up to three words
may be entered (provided the number of characters will fit on the screen). Press "8" to save all
words in memory.
The "A" with the flashing cursor over it will disappear, indicating that the word(s) are stored in
memory for that zone, as shown in the summary display at the left.
To enter a descriptor for the next zone, press  plus the desired zone number (e.g., 02). The
summary display following step 4 previously will appear. Now repeat steps 5 through 10 for the
descriptor for the next zone.
To exit the Alpha descriptor mode, press "+0+0" at the summary display.
This prompt will be displayed.
Press "0". This will be displayed.
Press 99 to exit the programming mode.
Section 5 – Menu Mode Programming
5-3