Section 3; Programming; Entering And Exiting Programming Mode; Data Field Programming Mode - First Alert FA2000C Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •

Entering and Exiting Programming Mode

Enter Programming mode using either method a or b:
a. Press both the [] and [#] keys at the same time
within 30 seconds after power is applied to the
control.
b. Enter the Installer Code + [8] + [0] keys.

Data Field Programming Mode

In the Programming Mode you may access any field
simply by entering either [] or [#] + the field number:
To write or change information in a field press []
•
+ the field number (27).
To read the information in a field press [#] + the
•
field number (#27).
When the entries for a field are completed, the keypad
beeps three times and advances to the next field.
NOTE: If the number of digits that you enter in a data
field is fewer than the maximum permitted (for
example, a phone number), the keypad displays the last
entry and waits. To proceed, enter [] + the next data
field you wish to program.

Programming

Exit the Programming mode by either method a or b:
a. Press [] + [9] + [8]. Exiting by this method
prevents the Installer Code from being used to re-
enter Programming mode. Only entry method "a"
can be used to re-enter the Programming mode.
b. Press [] + [9] + [9]. Exiting by this method
permits the installer code to re-enter the
Programming mode.
NOTE:
The system sends Program Mode Entry and Program
Mode Exit report codes to the central station upon
entering and exiting the program mode.
S E C T I O N 3
3-1