Chapter 2. Installation; Monitor Installation With Cameras - Hitron H4R15MX User Instructions

2-1. Monitor Installation with Cameras

The observation monitor must be installed by qualified service and installation personnel.
The installation must be in accordance with all local and federal electrical and building
codes.
Perform the following steps to install the observation monitor. See Figure 1.
A. Unpack the observation monitor.
B. Place the observation monitor in a convenient location.
Do not plug the power cord into a power outlet until step J.
Caution:
The MAIN POWER on the rear of the monitor must be turned off
before camera cables are plugged into the camera ports, which are
also on the rear of the monitor. Plugging a camera cable into the
monitor with the power on could damage the monitor and/or camera.
C. Select an appropriate location for the cameras.
D. Install cameras to be connected to the monitor.
E. Route the assembled cable from the monitor to the camera.
Caution:
Be careful when routing the cable from the camera to the monitor.
Try not to put unnecessary strain on the cable or connectors.
The cable can be damaged if pulled by the connectors.
Do not place the cable next to fluorescent lights; interference may
result.
Do not use staples to support the cable, as you may damage the cable.
If the provided camera cable is not long enough, do not substitute a
telephone cable. Using a telephone cable could damage the camera
and/or the monitor.
F. For modular type, plug the cable into the connector port labeled "MONITOR" on the
rear of the camera.
G. For BNC type, plug the cable into the connector port labeled "VIDEO OUT" on the
rear of the camera.
H. Plug the other end of the cable into the corresponding camera connector port on the
rear of the monitor. The ports are labeled "CA1" for camera one, "CA2" for camera
two, etc.
CHAPTER 2.
INSTALLATION
8