Installation With A Analog Vcr Or Security Time-Lapse Vcr - Hitron H4R15MX User Instructions

2-2. Installation with a analog VCR or Security Time-lapse VCR

The observation monitor has an internal hard disk for recording and playback.
But sometimes you may want to copy the playback of the internal hard disk using an
analog VCR tape.
At this time, perform the following steps after installing the monitor. See Figure 2.
A. Obtain the following equipment:
a. Analog VCR.
b. VCR interconnection cable.
c. Videotape.
B. Place the VCR in a convenient location.
(usually within reach of the observation monitor)
C. Plug the Modular connector of the VCR interconnection cable into the "RECORDER"
port on the rear of the monitor.
D. Connect the "Audio In" connector to the "Audio In" port on the VCR.
E. Connect the "Audio Out" connector to the "Audio Out" port on the VCR.
F. Connect the "Video In" connector to the "Video In" port on the VCR.
Use a RCA to BNC adapter if necessary.
G. Connect the "Video Out" connector to the "Video Out" port on the VCR.
Use a RCA to BNC adapter if necessary.
H. Press the VCR button on the front of the monitor.
I. Program the VCR using the manufacturer's instructions.
J. Press the mode button on the front of the monitor to return to a normal operation
mode.
K. Start recording using the manufacturer's instructions.
11