Installation With A Two-Way Intercom - Hitron H4R15MX User Instructions

2-5. Installation with a Two-way Intercom

The monitor has the ability to have a two-way intercom between the monitor and the
camera location.
Perform the following steps after installing the monitor. See Figure 5.
A. Obtain an intercom station.
B. Select a suitable location for the intercom station. The typical mounting height should
be between 30'' and 42'' above the floor for easy access.
C. Route the intercom cable from the observation camera to the intercom station.
D. Plug one end of the cable into the jack on the rear of the intercom station.
E. Turn OFF the MAIN POWER switch on the observation monitor.
F. Plug the RJ-11-E connector of the intercom cable into the interphone port, on the rear
of the camera.
Caution:
Be careful when routing the cable from the camera to the intercom station.
Try not to put any unnecessary strain on the cable or connectors.
The cable can be damaged if pulled by the connectors.
Do not place the cable next to fluorescent lights; interference may result. Do not
use staples to support the cable, as you may damage the cable. If the provided
camera cable is not long enough, do not substitute a telephone cable. Using a
telephone cable could damage the camera and/or alarm device.
G. Turn on the MAIN POWER switch for the observation monitor, and the POWER
switch on the front of the monitor.
H. Place the monitor in the desired operating mode.
CAMERA
To Monitor
INTERCOM
BACK OF CAMERA
MONITOR INTERPHONE
<FIGURE 5> Two-way Intercom Installation
17
CAMERA WITH BUILT-IN INTERCOM
VIDEO DOOR
PHONE CAMERA
To Monitor