07K5-059
Changing the Network Transmission Speed or Transfer Mode
Usually, you do not need to change the setting, since the transmission speed and transfer mode of the network are
detected automatically.
If the printer cannot communicate with other devices on the network successfully, set the network transmission speed or
transfer mode manually.
This section describes the procedure for changing the transmission speed and transfer mode using the Remote UI.
In the Remote UI, you can change the transmission speed and transfer mode by accessing the printer from a Web
browser via a network.
NOTE
When changing the transmission speed and transfer mode using software other than the Remote
UI
You can also change the transmission speed and transfer mode using the following software.
"FTP Client"
You can change the settings by accessing the FTP server of the printer using Command Prompt.
1
Start the Remote UI, and then log in as Administrator.
"Starting the Remote UI"
2
Select [Network] from the [Device Manager] menu.
3
Click [Ethernet Driver Setting] under [Network Interface].