Table of Contents
Advertisement
[IP Address]
[Subnet Mask]
[Gateway Address]
NOTE
When selecting [RARP]
You cannot enter any values in [IP Address].
When selecting [BOOTP] or [DHCP]
You cannot enter any values in [IP Address], [Subnet Mask], and [Gateway Address].
If you cannot use RARP, BOOTP, or DHCP
Specify the settings in [Manual Setting].
4
Click [OK].
5
Restart the printer. (Turn OFF the printer once, wait for 10 seconds or longer, and then turn it ON.)
After restarting the printer, the settings are effective.
Next, install the printer driver.
"Setting a Port and Installing the Printer
Obtains an IP address using BOOTP.
(The BOOTP daemon needs to be running.)
[DHCP]
Obtains an IP address using DHCP.
(The DHCP server needs to be running.)
Enter the IP address of the printer.
Enter the subnet mask as needed.
Enter the gateway address as needed.
Driver"
Advertisement
Table of Contents
