ATEN Master View CS-88A User Manual page 33

(F4 ADM: continued)
Setting
SET QUICK This function lets the Administrator select which Ports to include as
VIEW PORTS Quick View ports.
Note: Only the Ports currently chosen for the LIST view on the
main OSD screen (see p. 24), show up here.
M To select/deselect a port as a Quick View Port, use the
Navigation Keys to move the highlight bar to it, then
Press [Enter].
M When a port has been selected as a Quick View Port, an
arrowhead displays in the QV column of the LIST on the Main
Screen to indicate so. When a port is deselected, the
arrowhead disappears.
M If one of the Quick View options is chosen for the LIST view
(see p. 24), only Ports that have been selected here will show
up on the LIST display on the main OSD screen.
M If one of the Quick View options is chosen for Auto Scanning
(see p. 26), only Ports that have been selected here will be Auto
Scanned.
The default is for no ports to be selected.
SET This function allows the Administrator to define User access to
ACCESSIBLE the computers on the installation on a Port-by-Port basis. For
PORTS each User, select the target Port; then press the [Spacebar] to
cycle through the choices: F (Full access), V (View Only) or
blank. Repeat until all access rights have been set, then press
[Esc]. The default is F for all users on all Ports.
Note: A blank setting means that no access rights are granted.
The Port will not show up on the User's LIST on the Main Screen.
CS-88A User Manual
Function
2002-12-27
29