ATEN Master View CS-88A User Manual page 29

M F3 SET:
This function allows each User and the Administrator to set up their own
working environment. A separate profile for each is stored by the OSD and is
activated according to the Username that was provided during Login.
To change a setting:
1. Move the highlight bar to it, then press [Enter]
2. After you select an item, a submenu with further choices appears. To
make a selection, move the Highlight Bar to it, then press [Enter]. An icon
appears before the selected choice to indicate which one it is. The settings
are explained in the following table:
Setting
OSD HOTKEY Selects which Hotkey activates the OSD function: [Scroll Lock]
[Scroll Lock] or [Ctrl] [Ctrl]. Since the Ctrl key combination may
conflict with programs running on the computers, the default is
the Scroll Lock combination.
PORT ID Allows you to position where the Port ID appears on the screen.
DISPLAY The default is the upper right corner, but you can choose to have
POSITION it appear anywhere on the screen.
Use the Arrow Keys plus Pg Up, Pg Dn, Home, End, and 5 (on
the numeric keypad with Num Lock off), to position the Port ID
display, then press [Enter] to lock the position and return to the
Set submenu.
Note: The ID display position for each port on the installation is
set independently; the choice specified here only applies to the
currently active computer.
PORT ID Determines how long a Port ID displays on the monitor after a
DISPLAY port change has taken place. The choices are: User Defined -
DURATION which lets you select the amount of time (from 1 - 255 sec.); and
Always On - which displays the Port ID at all times. If you select
User Defined, key in the number of seconds, then press [Enter].
The default is 3 Seconds.
(Table continues on next page)
CS-88A User Manual
Function
2002-12-27
25