ATEN Master View CS-88A User Manual page 20

M Selecting the Active Port
Each CPU port is assigned a Port ID (see Port ID Numbering, p. 13). You
can directly access any computer on the installation with a Hotkey
combination that specifies the Port ID of the CPU Port that the computer is
connected to. The steps involved are:
1. Invoke Hotkey Mode (see p. 15)
2. Key in the Port ID
The Port ID numbers display on the Command Line as you key them in. If
you make a mistake, use [Backspace] to erase the wrong number.
3. Press [Enter]
After you press [Enter], the KVM focus switches to the designated
computer and you automatically exit Hotkey Mode.
Port Key In Examples:
M
To access a computer attached to Port 3 of a Single Stage installation, key
in 3 for the Port ID, as follows:
[Numlock] + [*] 3 [Enter]
M
To access a computer attached to Port 3 of a Second Stage unit that is
cascaded down from Port 2 of the First Stage unit, key in 23 for the Port
ID, as follows:
[Numlock] + [*] 2 3 [Enter]
Note: You must key in the numbers one at a time.
M
To access a computer attached to Port 8 of a Third Stage unit that links
back to Port 4 of a Second Stage unit, which, in turn, links back to CPU
Port 6 of the First Stage unit key in 648 for the Port ID, as follows:
[Numlock] + [*] 6 4 8 [Enter]
16 CS-88A User Manual
2002-12-27