Battery; Synchronizing Remote Control - BMW R nineT Rider's Manual

Synchronizing remote
control
Press and hold button 1 and
button 2.
LED flashes for ten seconds.
As soon as the LED goes out,
release button 1 and button 2.
LED lights up.
Press button 1 or button 2.
LED goes out.
Remote control is synchro-
nized.

Battery

with anti-theft alarm OE
When is a battery change
required?
The batteries of the remote con-
trol must be replaced after ap-
prox. 2 - 3 years. A weak battery
can be recognized from the fact
that the LED does not light up at
all or only briefly when a button is
pressed.
Replacing battery
Remove screw 2 and take off
lower housing section 1.
Slide old battery 5 forward un-
der retainer 3.
Batteries of the wrong type
or incorrect poling of the
batteries can destroy the device.
Use specified battery (see the
chapter "Technical Data"). En-
sure proper poling when inserting
the battery.
Install a new battery while mak-
ing sure that the positive termi-
nal of the battery is at the top.
Position lower housing section
on nose 6 of front edge and
close while watching two guide
pins 4.
Install screw 2.
The LED of the remote control
lights up; i.e. the remote con-
trol must be synchronized.
5
51
z