Replacing Led Tail Light; Jump-Starting - BMW R nineT Rider's Manual

8
90
Insert inside end of lens into
light housing and close.
z
Install screw 1.

Replacing LED tail light

The LED tail light can only be
completely replaced.
Please contact a specialist
service facility for this pur-
pose, preferably an authorized
BMW Motorrad retailer.

Jump-starting

The wires leading to the
power socket do not have
a load-capacity rating adequate
for jump-starting the engine. Ex-
cessively high current can lead
to a cable fire or damage to the
vehicle electronics.
Do not use the socket to
jump-start the engine of the
motorcycle.
A short-circuit can result
if the crocodile clips of
the jump leads are accidentally
brought into contact with the
motorcycle.
Use only jump leads fitted with
fully insulated crocodile clips at
both ends.
Jump-starting with a donor-
battery voltage higher than
12 V can damage the motorcycle
electronics.
The battery of the donor vehicle
must have a voltage of 12 V.
Make sure ground is level and
firm and park motorcycle.
Remove passenger seat
( 41).
Remove rider's seat ( 40).