Lcd Display; Alarm; Projection - Oregon Scientific DP200 User Manual

3. Press SET CLOCK to confirm.
4. The settings order is: time zone offset, 12/24 hr
format, hour and minute.
DP200: Time zone offset sets the clock +/- 23 hours
from the received clock signal time.
DP200A: Select the time zone: (P) Pacific, (E) Eastern,
(C) Central or (M) Mountain.

LCD DISPLAY

Wave your hand at least 3 inches above the IR motion
sensors to toggle display modes between:
Clock
•

Alarm

•
Outdoor temperature
•
Indoor temperature
•
ALARM
To set the alarm:
1. Press and hold SET ALARM.
2. Press / to set hour / minute.
3. Press SET ALARM to confirm.
ON.
To toggle alarms ON / OFF:
Press SET ALARM to display alarm time.
1.
Press ALARM ON / OFF to turn alarm ON / OFF.
2.
To silence the alarm:
• Wave your hand above the IR motion sensors to
silence it for 8 minutes.
OR
• Press ALARM ON / OFF to turn the alarm off and

PROJECTION

The ultra-bright LED enables daylight projection of time
and temperature information.
To activate projection:
Slide PROJECTION to AUTO or CLOCK.
•
•
To adjust the projection image:
• Press 180° ROTATION to rotate the image by
• Focus the projector image by turning the FOCUS
NOTE The installed CDS light sensor inside the unit
will activate automatic projection / display dimming.
NOTE If projection is illuminated, do not look directly
indicates alarm is
into the projector. Oregon Scientific will not be held
responsible for any results or consequences arising
from the misuse of this product.
5
activate it again after 24 hours.
Slide to AUTO to toggle between current time and
indoor / outdoor temperature.
Slide to CLOCK to project current time only.
180°.
wheel.