Table of Contents
Advertisement
Do Not Disturb
If you do not wish to be disturbed, you can set your
extension to prevent any calls from ringing to or
getting
through
to
Note: Hold/Quick Forward is the default setting for
the HOLD/DND key in the Iwatsu ICON 5810.
1. Do not lift receiver.
2. Press the Hold/DND key. The lamp on the Hold/
DND key will stay lit.
To cancel Do Not Disturb:
1. Do not lift receiver.
2. Press the Hold/DND key. The lamp on the Hold/
DND key will go out.
Exclusive Hold On Outside Line
A call on "exclusive" hold may only be picked up
from your extension.
While speaking on an outside call press the key
for the outside line you are already using. The green
lamp on that outside line key will flash slowly on
your phone. The red lamp will stay lit at other exten-
sions.
To retrieve a call on Exclusive Hold press the
same outside line key on your phone again to be
connected to the call.
Flash
Flash allows you to receive a dial tone on the same
outside line that you are using without having to
hang up. Flash may also be used to receive an
intercom dial tone to place another intercom call.
After you complete a call or if you make a dial-
ing mistake
1. Press Flash.
2. Dial the new number.
To Use Centrex or PBX features
1. Press S Flash:
2. Dial the new number or feature code.
If your phone does not have Flash or S Flash
keys
1. Press Feature then dial 1+1 for Flash.
2. Press Feature then dial 1+2 for Short Flash.
Hold/Quick Forward Operation
1. If programmed for Quick Forward operation,
pressing Hold/DND will automatically forward all
incoming calls to your active forward destination
or fixed call forward destination.
Note: Hold/Quick Forward is the default setting for
the Hold/DND key in the Iwatsu ICON 5930/5910.
21
your
extension.
Change the LCD Backlight Duration
The LCD backlight timer can be adjusted for each
5930 and 5910.
1. Press the Setup menu key.
2. Press User Options.
3. Enter your Station Password and press Enter.
4. Press the right navigation key to scroll to the
LCD Backlight Duration menu page.
5. Select LCD Backlight Duration.
6. Use the left or right navigation keys to scroll
through and select a backlight time of 30 se-
conds (default), 1, 3, 5, 10, 20, 30, 60, 90, or 120
minutes.
7. Press Save and Exit to save your change and
return to the main screen.
Caller ID On Hold
Enable / Disable Caller ID On Hold. When enabled,
self-labeling keys programmed for outside line ap-
pearance will display the caller ID name or number
of the held/parked caller.
1. Press the Setup menu key.
2. Press User Options.
3. Enter your Station Password and press Enter.
4. Press the right navigation key to scroll to the
Caller ID On Hold menu page.
5. Select Enabled (default) or Disabled.
6. Press Exit to return to the main screen.
10
Advertisement
Table of Contents
